Note: The clips cannot be clamped upside down, the red clip clamps the positive pole of the battery, and the black clip clamps the negative pole of the battery. Secondly, do not start the car continuously, there should be a interval of about 3 minutes in between!

When the product has just been received. First turn on the flashlight to discharge, then charge the product for more than 4 hours, and then start the car, because the product contains virtual electricity This operation can prolong the service life of the product!

Tips for daily maintenance:

1: The battery has a shelf life. Whether you use it or not, it is recommended to charge and discharge the battery once every 2-3 months.

2 When it is not used for a long time! Please keep 3 grids of power supply or more than 50% of power!

(Tips: Remember to charge the battery once every 2-3 months when you are not using it. If the power supply is low or the storage of virtual power has an impact on the battery, proper maintenance will last longer~~

 Before use, there is a small prompt

[1] that the car cannot be started by continuous ignition/or the key cannot be turned, and the positive and negative poles of

[2] can not be reversed after every 30 seconds of starting. The two clips cannot be short circuited.

[3] Remove the clip within 30 seconds after successfully starting the car.

Violation of the above three operations may cause the [fuse box] of the clip to burn out. Please pay attention to the operation method.

Feature:

Stable voltage, current, balance charge function.

Class A+ cell, safe and explosion protective.

Upgrade 4 cell and start strongly.

1000A Starting current.

2000A Peak current.

20000mAh Large Capacity.

Diesel 3.0L, gasoline 5.0L car can be used.

Reverse connection protection.

2 USB charging.

Full power can be started 40 times.

Limit temperature -20 ~ 60°C.

Intelligent Protection System.

Input: 5V-2.4A

Output: 5V-2.4A*2; 12V Jump Start

Night emergency, Rescue lighting:

1. Built-in glare lighting system.

2.Long press the middle button for 3 seconds.Press again in burst mode.

3. After turning on the flashlight,press the switch again to become a flash,the switch is the distress mode.